Rug Size Calculator
Rug size chart: standard sizes
Rugs are sold in standard sizes, so you pick from a short list rather than ordering a custom size. This is the full chart, with the metric equivalent for each size.
| Size (ft) | Size (cm) | Best for |
|---|---|---|
| 2 × 3 | 60 × 90 | Entryway, in front of a sink or door |
| 3 × 5 | 90 × 150 | Small bedroom, kitchen, beside a bed |
| 4 × 6 | 120 × 180 | Twin bed, small seating nook |
| 5 × 8 | 150 × 240 | Twin or full bed, apartment living room |
| 6 × 9 | 180 × 270 | Full bed, 4-seat dining table |
| 7 × 10 | 210 × 300 | Mid-size sofa, tight living room |
| 8 × 10 | 240 × 300 | Queen bed, standard living room, 6-seat dining table |
| 9 × 12 | 270 × 360 | King bed, large living room, 8-seat dining table |
| 10 × 14 | 300 × 420 | Large open-plan living room |
| 12 × 15 | 360 × 450 | Great room, very large seating group |
The rug size rules, room by room
Three rules govern nearly every rug decision. Get these right and the size almost picks itself.
Living room: size from the sofa, not the room
The idea: the rug belongs to the seating group, not to the room. At least the front legs of the sofa and every chair facing it should rest on the rug — that is what visually connects the furniture. The rug should run at least 6″ past each end of the sofa, and leave 12–18″ of bare floor between the rug and the walls (8–12″ in a small room).
How to do it: measure your sofa arm to arm, add 12″, and pick the standard size that covers it. A standard 84″ sofa lands on an 8′ × 10′. A large sofa or sectional usually needs a 9′ × 12′. If you want every leg on the rug — the most generous look — go one size up from the front-legs answer.
Bedroom: soft floor where your feet land
The idea: the rug sits under the lower two-thirds of the bed and reaches about 18–24″ past each side and the foot, so your feet land on rug when you get up. Keep the nightstands off the rug so it sits evenly.
How to do it: a queen bed takes an 8′ × 10′ placed sideways; a king takes a 9′ × 12′. A twin or full bed works with a 5′ × 8′. In a small bedroom, two runners — one on each side of the bed — are a good alternative to one big rug.
Dining room: chairs stay on the rug
The idea: this is the strictest rule in the house, because chairs move. Add at least 24″ to every side of the table: a chair pulled out to sit down travels roughly 16–20″, so a 24″ border keeps all four chair legs on the rug whether the chair is pushed in or pulled out.
How to do it: a 72″ × 36″ table (6 seats) needs a rug of at least 7′ × 10′; most people buy an 8′ × 10′ for the extra margin. An 8-seat table usually needs a 9′ × 12′. Measure the table with its leaves in if you use them.
Hallway: a runner, not a rug
The idea: a runner should leave about 3″ of floor showing on each side and 12″ clear at each end, so it reads as a runner rather than wall-to-wall carpet.
How to do it: measure the hallway wall to wall, subtract 6″ from the width and 24″ from the length. Standard runners come in 2′ × 8′, 2′6″ × 10′ and 3′ × 12′ — pick the nearest to your measurement.
How to measure your room
1. Measure wall to wall. Measure the length and width of the room in feet, at floor level. Note where doors swing and where radiators or built-ins stick out — the rug has to clear those.
2. Measure the furniture. Sofa arm to arm in inches, bed size, or table length and width. The calculator sizes the rug from the furniture, then checks it against the room.
3. Tape the outline. Before you buy, mark the rug’s outline on the floor with painter’s tape and live with it for a day. Walk around it, pull out a dining chair, open the doors. Two minutes of tape saves a return.
Rug size mistakes to avoid
Buying too small. The most common mistake by far. A rug that floats in the middle of the seating group makes the whole room look smaller. When in doubt, size up — designers almost always do.
Running the rug wall to wall. A rug that touches the walls reads as carpet, not as a rug. Leave at least 12″ of floor showing (8″ in a small room).
Forgetting the dining chairs. If the back legs catch on the rug’s edge every time someone sits down, the rug is too small — measure the table plus the chairs, not the table alone.
Skipping the rug pad. A pad stops slipping and adds cushion. Buy the pad 1″ smaller than the rug on all four sides so it stays hidden.
Frequently asked questions
What size rug do I need for a living room?
Most living rooms take an 8′ × 10′ rug with the front legs of the sofa and chairs on it. Larger seating areas and sectionals usually need a 9′ × 12′. Size from the sofa: add 12″ to the sofa’s length and pick the standard size that covers it.
What size rug goes under a queen bed?
An 8′ × 10′ rug, placed sideways under the lower two-thirds of the bed. It leaves about 18″ of rug on each side for your feet. A king bed needs a 9′ × 12′.
What size rug for a dining table?
The rug should be at least 24″ bigger than the table on every side. A 6-seat table (about 72″ × 36″) needs at least a 7′ × 10′, and most people choose an 8′ × 10′. An 8-seat table usually needs a 9′ × 12′.
How much floor should show around a rug?
Leave 12–18″ of bare floor between the rug and the walls in a living room or bedroom, and 8–12″ in a small room. In a hallway, leave about 3″ on each side of a runner.
Should the rug go under the sofa?
At least the front legs should sit on the rug — that is the layout most designers use, and it works with an 8′ × 10′ in a standard living room. Putting all four legs on the rug looks more generous and needs a 9′ × 12′ or larger.
Looking for more ideas for the room around your rug? See our dark and cozy living room ideas, a small bedroom reading nook under $75, and the rest of our free home decor tools.